Step 1: Enable Multi Decode Mode

Go to USS > Scanner Settings, then enable Multi Decode Mode.

Step 2: Set the Multi Decode Count

Under Multi Decode Count, enter the number of barcodes you expect to scan.
For example, set Multi Decode Count = 10 if you want to scan up to 10 barcodes in one Multi Read session.

Step 3: Configure Multi Decode Full Read

Choose whether to enable or disable Multi Decode Full Read based on how you want the scanned data to be output.

Full Read OFF: Scanned data can be output without reaching the preset Multi Decode Count. This is better suited for workflows where the number of barcodes may vary.

Full Read ON: Data is output only after the preset Multi Decode Count is reached. This is better suited for fixed-quantity workflows and can help reduce missed scans. 

Why Should I Set a Multi Decode Count?

The Multi Decode Count defines the expected number of barcodes in a Multi Read session and helps determine when scanned data is output.

Can I Change the Multi Decode Count at Any Time?

Yes. You can change the Multi Decode Count in USS > Scanner Settings whenever needed to match the number of barcodes required for your scanning task.